Undersink Reverse Osmosis - 4 Stage with Permeate Pump PT-4.0/PP

Sale: $330.00
Item Number: PT-4.0/PP
Manufacturer: Vertex
: PT4.0/PP

High Efficiency System
 
The PT-4.0/PP is complete, ready to install, with instructions.  The 4-Stages are pre-assembled and tested.  The faucet, inlet water valve, drain saddle connection, storage tank valve, permeate pump, and color coded plastic tubing for undersink installation are all included.
Install anywhere with permeate pump

This model a uses a non-electric permeate pump which is placed after the flow restrictor in the brine discharge line. This recovers pressure energy from the brine and forces product water to the storage tank.This reduces the membrane back pressure and increases its efficiency. The tank pressure will be brought to 90% of the inlet pressure, (instead of 67%) thus increasing the flow from the faucet. In this system the normal autovalve is replaced by the permeate pump.

Use this model where the water pressure is marginal (30-45 psi) and/or the TDS is high, and there is no power available for a booster pump. Alternately, this permeate pump may be added to improve performance of an installed unit.
 
Features
Auto Shut-off valve (conserves water)
 Flow Restrictor modified capillary
Long Reach, Non-airgap Faucet
Feed water connector Threaded Inlet Adapter with Metal Ballvalve Drain Clamp
1/4 Inch Flexible Polyethylene Tubing w/JACO Compression Fittings
Stage One
Sediment Filter, 5-Micron Polyspun Cartridge, 2 1/2 dia. x 9 3/4" long
Stage two
Activated Carbon Block Filter
5 Micron, 2 1/2 dia. x 9 3/4" long
Stage Three
Reverse Osmosis Membrane, Filmtec 36 GPD TFC @ 65 PSI Pressure Differential
Stage Four
Post-Filter, In-Line, Granular
Activated Carbon, 2 dia. x 10 long
Tank
4.0 Gallon Plastic Tank (metal tank available), Pre-pressurized with Butyl Bladder, 2.5 gal. water capacity

 

General Information
Shipping Weight: 25 lb.
Dimension: 14 L x 7 W x 18H
Tank: 11 dia. x 15 12H
Booster Pump: 24-36 volt DC flow through diaphram pump with 110VAC/ 24-36VDC60hz transformer

Conditions of Use
Water Must be microbiologically safe
Temperature, 40 -100 degrees F
pH Range, 3 to 11
Feed pressure, 20 to 100 psig
Maximum TDS, 1500 PPM
Turbidity, less than 1.0 NTU

RELATED PRODUCTS